Basic PLC S7-300 Program! 06.03.2009
1/ PURPOSES:
Contents:
CHAPTER 1: INTRODUCTION OF PLC S7 – 300 HARDWARE
1. Kinds of CPU
Extended Modules & Ways To Connect.
1. Methods To Locate
Modules of Communications & Application
Equipments of Disperse & Application
CHAPTER 2: INTRODUCTION OF STEP 7 PROGRAM SOFTWARE
2 To create a PLC program by STEP 7 Software.
2 Systems of signals & addresses.
2. Methods of ladder program
2 Translation, Download, Upload & Programe Online Supervision.
CHAPTER 4: STRUCTURE OF CONTROL PROGRAM
4 Structure of orderly programs
4Structure of Segment Program & Subprogram.
CHAPTER 5: TO HANDLE ANALOG SIGNAL
Introduction of Analog signal
5 Methods of handle & adjust
CHAPTER 6: ESTABLISHMENT OF PROFIBUS DP NETWORK CONFIGURATION
6Overview of Profius - DP
Structure of Profibus – DP System
Establishment of PLC-PLC Network Configuration on Profibus-DP
PRACTICE
There will be specific exercises for learners to practise after finishing each lesson. Learners will be practiced on PLC Simatic S7-300 combined with copied software of Siemens.
CERTICATE :
Certificates will be granted by Toandien Total Automation – Electrical Technologies Co.,Ltd.
CHAPTER 3: PLC PRACTICE Operations on Bit
Operations on Byte, Word & Double Word
Counter & Timer
3. Time : 40 periods (including Theory & Practice)
To maintain, to check and to replace hardware on PLC S7-300 system.
2/ REQUIREMENTS:
Learners are technical officers having basic knowledge of designing , operating and repairing automatic control system.
To train knowledge of definitions, the ability of program & design of automatic control system on SIEMENS’ PLC SIMATIC S7-300. After finishing the course, learners are able to :
- To select equipments , to design connects & to programme a system on PLC S7-300.
To read, to analyse, to adjust and to improve some existing programs.
Tiếng Việt 
.jpg)
